Confirming The Completion Of The Installation - Sony SU-WL500 Manual De Instrucciones

3
Firmly secure the monitor and
the Base Bracket using the
screws supplied with SU-WL500
(+BVST4 × 12).
Note
When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
WARNING
Be sure to tighten the securing screw firmly.
If you fail to do so, the monitor may fall
when it is pushed upward and cause injury.
Confirming the
completion of the
installation
Follow the instructions in the SU-WL500 instruction
manual to confirm.
When removing the
monitor
Follow the instructions in the SU-WL500 instruction
manual to remove.
Screw
(+BVST4 × 12)
9
(GB)