Nice Ten TN2010 Instrucciones Y Advertencias Para El Instalador página 18

7.2.3) LEVEL 2 functions (adjustable parameters)
Table 10: List of programmable functions: Level 2
entryled Parameter
L1
Pause Time
L2 SS function
L3
Motor speed
FLASH
L4
Output
Motor force
L5
on opening
Motor force
L6
on closure
Maintenance
L7
notification
Note: " " represents factory settings
18
Led (level)
L1 10 seconds
L2 20 seconds
L3 40 seconds
L4 60 seconds
L5 80 seconds
L6 120 seconds
L7 160 seconds
L8 200 seconds
L1 Open - Stop - Close - Stop
L2 Open - Stop - Close - Open
L3 Open - Close - Open - Close
L4 Apartment block
L5 Apartment block 2 (more than 2" causes stop)
L6 Step-by-Step 2 (less than 2" causes partial open)
L7 Hold-to-run
L8 Opening in "semiautomatic", closure in "hold-to-run" mode
L1 Speed 1 (30% - low)
L2 Speed 2 (44%)
L3 Speed 3 (58%)
L4 Speed 4 (72%)
L5 Speed 5 (86%)
L6 Speed 6 (100% - high)
L7 Open V4, close V2
L8 Open V6, close V4
L1 Door open indicator" function
L2 Active if door closed
L3 Active if door open
L4 Flashing light
L5 Electric block*
L6 Electric lock
L7 Suction cup
L8 Maintenance indicator
L1 Force 1 (low
L2 Force 2
L3 Force 3
L4 Force 4
L5 Force 5
L6 Force 6
L7 Force 7
L8 Force 8 (high)
L1 Force 1(low)
L2 Force 2
L3 Force 3
L4 Force 4
L5 Force 5
L6 Force 6
L7 Force 7
L8 Force 8 (high)
L1 Automatic (based on the gravity of the manoeuvres)
L2 1.000
L3 2.000
L4 4.000
L5 6.000
L6 8.000
L7 10.000
L8 12.000
Value Description
Adjusts the pause time, i.e.
time before automatic closure.
Is effective only if automatic
closure is enabled
Adjusts the sequence of com-
mands associated with the SS
input or the radio command.
Sets the motor speed during
normal travel.
Selects the device connected
to the FLASH output. Before
changing settings, take care
to ensure that the device con-
nected to the FLASH terminal
is as described in paragraph
3..4.1 "Description of electrical
connections".
Sets the motor force control
system to adapt it to the
weight of the door during the
opening manoeuvre and con-
sequently the obstacle detec-
tion sensitivity.
Sets the motor force control
system to adapt it to the
weight of the door during the
closing manoeuvre and con-
sequently the obstacle detec-
tion sensitivity.
Sets the number of manoeu-
vres after which the mainte-
nance request signal can be
enabled (see paragraph "7.4.3
Maintenance notification".
SEGUE