Initial Assembly - Kohler K-7202 Guia De Instalacion

Plug
Waste Ferrule
Waste Flange
Waste Seal
Waste Body
Coupling Nut
Compression Ring
Compression Seals
Compression Ring
Coupling Nut

1. Initial Assembly

:
NOTE When installing this drain on bath models K-1110-M and
K-1110-V, 2-1/4" (5.7cm) must be removed from the brass tubing on
the overflow portion of the drain assembly.
- Remove the overflow body, waste body, tailpiece and tee from the
packaging.
- Remove the coupling nuts, compression rings and compression seals
from the tee.
- Slide a coupling nut, compression ring and compression seal on the
overflow pipe, as shown. Repeat this process on the waste pipe and
tailpiece.
- Fit the overflow, tailpiece and waste pipes into the tee. Hand tighten
the coupling nuts onto the tee allowing movement of both the
overflow and waste bodies. Do not fully tighten at this time.
Kohler Co.
Waste Pipe
Tee
Tailpiece
3
Control Knob
Overflow Ferrule
Back Plate
Overflow Seal
Hex Wrench
Spanner
Overflow Body
Overflow Pipe
Coupling Nut
Compression Ring
Compression Seal
1013265-2-
C