Maintenance; Battery Installation Or Replacement - Promax MD-200B Manual De Instrucciones

USER'S MANUAL. MD-200B

4 MAINTENANCE

Battery installation or replacement

4.1
Meter is powered through the mains or 6 piece of 1.5V battery. Refer to Figure
3 and use the following procedure to replace the battery:
1. Disconnect test leads from any circuit under test, turn the ON/OFF switch on the
rear panel to off and remove the test leads from the meter.
2. Open the accessory compartment by pressing back and up on the button.
Remove any stored accessories.
Opened by screwdriver
Opened by coin
Figure 3.- Battery replacement
3. Using a slot-head screwdriver, key, or other appropriate tool, pry open the top of
the battery cover and lift the cover out.
ATTENTION Use only 1.5 V LR6 type batteries.
:
4. Disconnect the battery connector leads and remove the battery from the battery
box.
5. Replace the new battery to battery box and snap the battery connector leads to
the terminals on battery box.
6. Reinsert the battery convert in the multimeter.
03/2006
All manuals and user guides at all-guides.com
Battery box
Battery connector
Battery (1.5Vx 6)
Battery cover
Button
Page 19