Kohler K-7825 Guia De Instalacion página 4

Valve
Body Inlet
Coupling
Nut
3. Install the Supplies
NOTE: If the supply tubes need to be cut, allow for required
penetration of the tube into the supply stop.
NOTE: If the sink is not installed, install it at this time. Follow all
instructions packed with the sink.
Remove the burrs from all tubing cuts.
Slip the coupling nuts onto the supply tubes.
Position the round end of the supply tube (either flared or
ferrule) squarely into the valve body inlet.
Handtighten the coupling nuts.
Carefully bend the supply tubes to align them with the supply
stops.
Slide the coupling nuts and ferrules from the stops onto the
supply tubes.
Insert the supply tubes into the outlets of the shut-off valves.
Tighten the coupling nuts on the shut-off valves.
Turn on the water supply.
111058-2-AE
Ferrule or
Flared End
Supply
Supply
Tube
Stop
4
Supply Tube
Coupling
Nut
Ferrule
Kohler Co.