Pegasolift W12 Guia Uso Y La Mantenimento página 177

Take care when the material is concentrating in one part: if there is not possible to
!
obtain a perfect stability of the load, it is adequate to tie up it and to move slowly,
paying maximum attention.
The overload compromises the stability and the efficiency of the device: as it is shown
!
in figure A of page 11 the load will be put as near as possible to the head of the lifting
group in order to distribute more equally the weight on the four wheels.
Announce immediately to the surveyor all possible irregular utilizations, damages and
failures.
Report any occurred incident, even if there are no consequences, because in such a
way the reasons can be found and thus to eliminate them.
In the case of the stop of the stacker due to electric or mechanic failures, announce
the responsible persons in order to make the necessary repairs which should be
done only by authorized personal.
Avoid to use the stacker being dressed with large or fluttering clothes
!
There is prohibited to come nearer to the parts in movement of the stacker with long
!
hair not tied.
Avoid using clothes dirty of oil or fuel because these are easily to get burnt.
!
When using the stacker or normal maintenance operations are executed, put on the
!
head a rigid cap and safe shoes; it is compulsory to use safety glasses and gloves
during the maintenance of the battery and of the oleodynamic central (the electrolyte
and the hydraulic oil could produce permanent damages to the sight and skin.
There is strictly prohibited to bring not-authorized modifications to the stacker devices
and mechanic part without the previous authorization of the only constructing company:
the modifications could compromise the stability and the functionality of the stacker and
of its safety protections implying a danger.
Concerning the utilization and the assimilation of the products used for the stacker
cleaning and maintenance, there should be respected the laws in force of the respective
country; in the case of stacker dismantlement, observe the anti-pollution norms in force
in the country of utilization.
RECAPITULATION: EXECUTE ALWAYS GRADUAL STARTS AND SLOW DOWNS,
MAINTAINING THE LOAD COMPLETELY PUT ON THE FORKS AT A MAXIMUM
HEIGHT OF 30 CM FROM THE SOIL; CONTROL THE STABILITY OF THE LOAD.
THE LIFTING AND LOWERING OPERATIONS SHOULD BE ALWAYS EXECUTED
WITH A STOPPED STACKER.
PAY ALWAYS MAXIMUM ATTENTION TO YOUR OWN WORK: A SHORT MOMENT
OF INATTENTION COULD PROVOKE SEVERE INJURIES TO YOU AND TO THE
OTHERS, AS WELL AS DAMAGES TO THE stacker AND MATERIALS.
W10 INOX
GENERAL NORMS OF SAFETY
FAILURE SIGNALLING
CLOTHES
NOT-AUTHORIZED MODIFICATION
ECOLOGY AND POLLUTION
12
UK12