Specific Safety Rules - Craftsman 151.30381 Manual Del Usuario

SPECIFIC SAFETY RULES

■ Make sure your extension cord is in good
condition. When using an extension cord, be
sure to use one heavy enough to carry the
current your product will draw. A wire gauge
size (A.W.G.) of at least 14 is recommended
for an extension cord 50 feet or less in length.
If in doubt, use the next heavier gauge. The
smaller the gauge number, the heavier the
cord. An undersized cord will cause a drop
in line voltage resulting in loss of power and
overheating.
■ Do not point the blower nozzle in the
direction of people or pets.
■ Never place blower on any surface, except
a hard, clean surface when motor is running.
Gravel, sand, and other debris can be picked
up by the air inlet and thrown at the operator
or bystanders, causing possible serious
injuries.
■ Never run the unit without the proper
equipment attached. Always ensure the
blower tubes are installed.
■ When not in use, blower should be stored
indoors in a dry, locked up place - out of the
reach of children.
SAVE THESE INSTRUCTIONS
■ Maintain tool with care. Keep fan area
clean for best and safest performance. Follow
instructions for proper maintenance.
■ Do not attempt to clear clogs from tool
without first unplugging it.
■ Do not pull or carry by cord, use cord as
a handle, or pull cord around sharp edges
or corners. Keep cord away from heated
surfaces.
■ Do not unplug by pulling on cord. To
unplug, grasp the plug, not the cord.
■ If the power supply cord is damaged, stop
using the unit.Take the unit to a qualified
service dealer for inspection and possible
repair.
Save these
■
instructions.
Refer to them frequently and use them to
instruct others who may use this power tool.
If you loan someone this power tool, loan
them these instructions also.
5 ― English