Operating Instructions - Schumacher Electric INDUSTRIAL Serie El Manual Del Propietario

allows the electrolyte to be suspended in close proximity with the plate's
active material. In theory, this enhances both the discharge and recharge
efficiency. Actually, the AGM batteries are a variant of Sealed VRLA bat-
teries. Popular usage high performance engine starting, power sports,
deep cycle, solar and storage battery. AGM batteries are typically good
deep cycle batteries and they deliver best life performance if recharged
before the battery drops below the 50 percent discharge rate. If these
AGM batteries are discharged to a rate of 100 percent the cycle life will
be 300 plus cycles and this is true of most AGM batteries rated as deep
cycle batteries.
• GEL – Set button to GEL CELL. The Gel Cell is similar to the AGM style
because the electrolyte is suspended, but different because technically
the AGM battery is still considered to be a wet cell. The electrolyte in a
GEL cell has a silica additive that causes it to set up or stiffen. The re-
charge voltages on this type of cell are lower than the other styles of lead
acid battery. This is probably the most sensitive cell in terms of adverse
reactions to over-voltage charging. Gel Batteries are best used in VERY
DEEP cycle application and may last a bit longer in hot weather applica-
tions. If the incorrect battery charger is used on a Gel Cell battery, poor
performance and premature failure is certain.
The Gel Cell and the AGM batteries are specialty batteries that typically
cost twice as much as a premium wet cell. However they store very well
and do not tend to sulfate or degrade as easily as a wet cell. There is little
chance of a hydrogen gas explosion or corrosion when using these bat-
teries; these are the safest lead acid batteries you can use. Gel Cell and
some AGM batteries may require a special charging rate.
Charge Rate Button
Use this button to set the maximum charge rate to one of the following:
• 4A Charge Rate
commonly used in garden tractors, snow mobiles and motorcycles.
20A and 70A Charge Rate
•
batteries. Not intended for industrial applications.
10.

OPERATING INSTRUCTIONS

Charger Operation
NOTE: Once automatic charging or flash reprogramming has started, the
buttons will not work until you turn off the output, with the exception of the
Start/Stop (
) buttons also still operate normally.) When the display shows  no
buttons will work for five seconds as the charger automatically goes back
to the default settings.
Automatic Charging
1. Connect the battery and AC power following the precautions listed in
sections 6, 7 and 8.
– Intended for charging small batteries such as those
– Use for charging automotive and marine
) button. (In MANUAL mode the "UP" and "DOWN" (
9
• •
and