How It Works; Putting Into Operation - Boneco 2055 Manual Del Usuario

Unpacking
• Remove the appliance carefully from the packaging.
Warning: The upper part is only placed loosely on the
base (10 – 12).
en
• Remove the plastic bag from the unit (13).
• Check the details of the mains supply on the rating
plate (14).
• Use the original packaging to store the appliance if you
do not use it throughout the year.

Putting into operation

The best location for your appliance is:
• On the floor, or on a level, dry surface in the room.
• Pay proper attention to easy accessibility and sufficient
space for servicing and cleaning the unit.
• For increased evaporation performance in large rooms,
place the appliance near a radiator (warning: a tempe-
rature of 50 °C must not be exceeded).
• Read the section "Filling the tank" on how to fill the
water tank (19 – 22).
• Place the water tank on the lower part (23).
• Connect the mains cable to the mains and switch the
appliance on using the On/Off switch.
• The unit will reach full capacity about 10 – 15 minutes
after you switch it on.
• Ensure that the mains cable is not trapped (6). Do not
switch on the unit if the mains cable is defective (2).
20
10 11
12 13
14

How it works

Your appliance
• washes and humidifies the air without using filter mats
• works quietly in two operation modes
• is manufactured from high-quality, long-life
components.
• has a large cleansing capacity through pre-ionisation.
The individual dust particles are ionised (charged) and
stick to the humidifier disks.
Special humidifying disks rotate in a water bath inside the
unit; this cleanses the air passing over them of impurities
in a natural way – in the same was that air is washed by
the rain in nature.
The air humidification takes place according to the self-
regulating principle of cold evaporation. The appliance
therefore generates ideal air humidity, without the need for
additional control units.
A specially tuned anti-bacterial protection system (Ionic Sil-
ver Stick ® ) prevents the formation of germs in the water of
the base unit. No chemical additives are therefore required
to keep the water clean.