Symbols; Safety Instructions - Festool SYSLITE STL 450 Manual De Instrucciones

English
Contents
1 Symbols........................................12
2 Safety instructions....................... 12
3 Intended use................................ 13
4 Technical data..............................13
5 Parts of the device....................... 14
6 Commissioning............................ 14
7 Setting up..................................... 14
8 Maintenance and care................. 15
9 Environment.................................15
1

Symbols

Warning of general danger
Warning of electric shock
Read the operating man­
ual and safety warnings.
CAUTION! Do not look di­
rectly into the light beam!
The surface temperature
should not exceed 90 °C
D
on horizontal and 150 °C
on vertical outer surfaces.
Device suitable for "harsh
operating conditions" in
accordance DIN EN 60598.
Do not dispose of it with
domestic waste.
Handling instruction
12
2

Safety instructions

WARNING! Read and observe
all information and safety in­
structions. Failure to observe
the information and safety instructions
may lead to electric shocks, fires and/or
serious injuries.
Keep all safety information and in­
structions for future reference.
Handle the device with care. The
-
device may generate heat which in­
creases the risk of fire and explo­
sions.
Never use the device in potentially
-
explosive environments.
- Do not cover the device when
switched on. The device heats up
during operation and can cause
burns.
Warning of harmful light
-
radiation. Do not look into the light
beam for long periods. Do not di­
rect the light beam towards other
people or animals. Optical radiation
can damage the eyes.
Do not use the device for illuminat­
-
ing the road. The device is not ap­
proved for illuminating the road.
Do not connect the device to a pow­
-
er supply when it is wet. If the de­
vice falls into water, it must be dried
before being connected to a power
supply.
Check the mains plug and the pow­
-
er cable regularly in order to pre­
vent a hazard. Disconnect any dam­
aged power cables from the power
supply immediately and have them
replaced by an authorised service
workshop.