Features; Built-In Redundancy; Hot Swap; Physical Description - Dell PowerConnect W-6000 Guia De Instalacion

The Dell PowerConnect W-6000 controller Fan Tray (HW-FT) provides air circulation for cooling the W-
6000M3 modules in the Dell PowerConnect W-6000 controller chassis and is required for their normal operation.
Normal operating temperature for the W-6000 controller chassis is between 0 to 40 ºC (32 to 104 ºF). If this
temperature range is exceeded, the W-6000 will provide a warning through the software to alert users of the
change. The following table describes these alarms and their thresholds:
Table 3
Temperature Thresholds
Alarm Severity
Minor
Major
Critical
This chapter describes the general features and physical characteristics of the fan tray, and provides instructions
for replacing the module if necessary.

Features

Built-in Redundancy

Three fans are provided in the fan tray. The module is designed to provide for cooling, even if one fan fails. Any
two operating fans will provide enough airflow for proper cooling until the fan tray can be replaced.

Hot Swap

Hot swapping should be performed by a trained technician. Hot swapping allows you to replace the fan tray
without having to shut down the system. During the replacement operation, the chassis will continue to function
without fans, though the procedure must be completed within one minute to resume proper cooling.

Physical Description

The fan tray slot is located on the left side of the W-6000 controller chassis and extends from the front of the
chassis to the back.
Dell PowerConnect W-6000 Controller | Installation Guide
Threshold
40 ºC
50 ºC
60 ºC
Chapter 4
The Fan Tray
The Fan Tray | 17