Dell Powerconnect W-6000 Controller | Installation Guide - Dell PowerConnect W-6000 Guia De Instalacion

3. Verify the power switch on the power supply to be installed is Off ( ).
CAUTION: Never insert or remove a power supply while its power switch is in the On (|) position or if the power cord is
plugged into the power supply module. Verify the power switch is Off ( ) first and that the power cord is unplugged from the
W-6000 PSU module.
4. Insert the power supply into the chassis.
Grasp the power supply by the handle attached along the bottom side of the power supply, keeping the LEDs
on the left and power switch on the right. Do not use the power cord retaining clip to insert or remove the
power supply. Align the back of the module with the guide-rails in the chassis power supply slot and gently
slide the module toward the backplane. Do not force the module; it should slide in easily most of the way.
There may be moderate resistance when the power supply meets the connectors at the back of the chassis.
Press firmly to engage the connectors, but do not use excessive force.
5. Secure the power supply.
Use the screwdriver to push in the module's captive fastening screws and turn them clockwise until moderate
resistance is felt. Do not over-tighten.
6. Attach the power cord to the power supply.
NOTE: Swing the cord retaining clip to the left before attaching the power cord.
Plug an appropriate power cord into the power input socket. The socket accepts a power cord with a standard
IEC320 plug.
CAUTION: For proper safety and performance, the power cord must be rated to 10 A and conform to grounded electrical
standards in the country where the product is operated.
7. Secure the power cord.
When the power cord is attached, swing the power cord retaining clip to the right as shown in
page
Figure 8
8. Attach the power cord to a proper electrical outlet.
Verify that your site's electrical systems can handle the power load for the W-6000.
Each power supply (HW-PSU-400) is rated at 400 W total and is auto-ranging to accept 85 to 264 VAC, at
50 to 60 Hz.
26 | The W-6000 Power Supply Module
26. This will hold the plug in place and help prevent it from being removed accidentally.
Using the Power Cord Retaining Clip
Right: Capture Cord Wrong: Around Plug Base

Dell PowerConnect W-6000 Controller | Installation Guide

Figure 8 on