Lcd Display Symbols; Getting Started; Unpacking The Product; Batteries - Oregon Scientific JM888 Manual De Instrucciones

Reloj de pared radio-controlado para uso exteriorcon termómetro
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 17

LCD DISPLAY SYMBOLS

1. Time zone
2. Hourly chime indicator
3. Time display
4. Low battery icon for UV sensor
5. UV (Ultraviolet) index level indicator
6. UV Index
7. Local temperature / UV index display - Displays
currently monitored temperature / UV index
8. Radio reception signal - Indicates the condition of
radio reception
9. Low Battery - Appears when power is low
10. Current date display - Displays current date

GETTING STARTED

UNPACKING THE PRODUCT

When you unpack your clock, make sure to keep all the
packing materials in a safe place, in case you need to
later transport or return it for servicing.
In the box, you will find:
Clock unit

Batteries

User manual
BATTERIES
To load the batteries:
1. Locate the battery compartment.
2. Unscrew the four small screws from the battery
compartment.
3. Install the batteries by matching the correct polarity.
Always use the correct battery type (2 x UM-3 AA-
sized 1.5V batteries).
WARNING Reversing the polarity may damage the
product.
NOTE Replace the batteries whenever the
battery icon is shown, the display is dim, or the display
does not illuminate when the power is on. Replace all the
batteries at the same time - it is dangerous to mix old and
new batteries.
NOTE If the battery voltage level is low, the
battery" icon will be displayed.

PLACEMENT OF UNIT

You can either mount the main unit on a wall or make it
stand on a flat surface.
Table stand - The unit is already equipped with a table
stand. Simply pull out the table stand and rest the main
unit on a flat surface.
Wall mount - The main unit can be mounted onto a wall
using a No. 6 screw (3.0mm).
1. Position and nail the screw into the place where
you would like to hang your main unit.
2. Leave ample space between the wall and the
screw head while testing to make sure the nail is
secure.
3. Fit the unit's wall-mount recess hole onto the
screw head.
3
low
"low

Publicidad

Tabla de contenido
loading

Tabla de contenido