Dust Extraction; Working With The Machine - Festool KA 65 Manual De Instrucciones

KA 65
GB
Purging process is carried out
2
190 °C
Adhesive nozzles are open,
pressure has built in the adhe-
sive cartridges. Display of the
current status.
Cooling mode
180 °C
The machine reduces the tem-
perature in cooling mode and
then switches off. Cooling mode
is activated when:
–on/off switch [1-8] is pressed
< 1 s
–no controls are actuated for
more than 15 minutes
The machine is switched on
again by pressing the start but-
ton [1-1] or the on/off switch
[1-8].
Fault symbol
0 Troubleshooting (chapter 12).
**
Automatic calculation of currently detected edge
height
7.6

Dust extraction

CAUTION
Vapours emitted during the glueing process!

Ensure there is good ventilation.

Use an extractor.

Always observe national regulations.
An extractor hose with a diameter of 27 mm can be
attached to the extractor connector [1-6].
8

Working with the machine

WARNING
High temperatures on the heating unit and adhe-
sive nozzle!
Risk of burns when touched

Wear suitable protective gloves.

Always hold the machine by the insulated han-
dles [1-3], [1-16]!
18
WARNING
Moving workpiece!
Risk of injury from sliding workpiece

Always secure the workpiece in such a manner
that it cannot move.
8.1 Glueing the edge band

Cut the edge band down to size, leaving an al-
lowance of approximately 10 cm.

Switch on the machine [1-8].

Select the temperature setting [1-7].
Display [1-20] lights up red = actual and set-
point temperature are displayed. Machine is not
yet ready for operation.
Display [1-20] lights up green = operating tem-
perature reached. Setpoint temperature is dis-
played.
Machine is now ready for operation.

Adjust the relevant settings (chapter 7).

Press the start button [1-1] once.
Edge inlet mechanism starts up.

Guide the edge band into the edge inlet within 20
seconds [1-11].
The time remaining is shown on the display
.
[1-20]
The edge band is drawn in automatically up to
the light barrier [3-4] .
Inlet stops.

Position the machine on the workpiece [4-1]
approx. 2 cm away from the contact roller [4-3]
with reference to the start marking [4-2] [4].
The start marking [4-2] and edge of the work-
piece must be flush with one another.

Press the start button [1-1] again.
Inlet starts.
Wait until the edge band with adhesive is visible.

Push the machine down onto the workpiece and
guide lengthways from right to left [5]. Exert
pressure on the support base and against the
workpiece. Applying pressure in the feed direc-
tion is not necessary.
The edge feed mechanism moves the machine
forwards automatically.
Once the edge band has passed through the
feed completely, the mechanism stops automat-
ically after a short delay.