Important Safety Instructions; Warning Range Tipping Hazard - Bosch HDS252U Instrucciones De Installación

WARNING
RANGE TIPPING HAZARD
• All ranges can tip and injury could result. To prevent
accidental tipping of the range, attach it to the floor by
installing the Anti-Tip Device supplied.
• A risk of tip-over may exist if the appliance is not
installed in accordance with these instructions.
• Install anti-tip device packed with range.
• If the range is pulled away from the wall for
cleaning, service, or any other reason, ensure that the
Anti-Tip Device is properly reengaged when the range
is pushed back against the wall. In the event of abnormal
usage (such as a person standing, sitting, or leaning on
an open door), failure to take this precaution could
result in tipping of the range. Personal injury might
result from spilled hot liquids or from the range itself.
WARNING
Before installing, turn power OFF at
the service panel. Lock service panel
to prevent power from being turned
ON accidentally.
CAUTION
Unit is heavy and requires at least
two persons or proper equipment
to move.
For Massachusetts Installations:
1. Installation must be performed by a qualified or
lisensed contractor, plumber or gas fitter qualified or
licensed by the state, province or region where this
appliance is being installed.
2. Shut-off valve must be a "T" handle gas cock.
3. Flexible gas connector must not be longer than 36
inches.
HIGH ALTITUDE INSTALLATION NOTE:
For installation at altitudes above 2,000 ft., contact Bosch
Service (800-994-2904) for special instructions.
!

IMPORTANT SAFETY INSTRUCTIONS

IMPORTANT:
LOCAL CODES VARY. INSTALLATION, ELECTRICAL
CONNECTIONS AND GROUNDING MUST COMPLY WITH ALL
APPLICABLE CODES.
• Proper Installation - Be sure your appliance is properly
installed and grounded by a qualified technician in accordance
with the National Electrical Code ANSI/NFPA No. 7 latest edition
and local electrical code requirements.
• This appliance has been tested in accordance with ANSI Z21.1,
Standard for Household Cooking Appliances (USA) and in ac-
cordance with CAN 1.1-M81 Interim Reqt #58 Domestic Gas
Cooktops (CANADA).(In Canada, installation must be in accor-
dance with the CAN 1-B149.1 and .2 Installation Codes for Gas
Burning Appliances and/or local codes)
• It is recommended that the range be used in conjunction with
a suitable ventilation system.
The following must be met when testing supply piping system:
a) The appliance and its individual shut-off valve must
be disconnected from the gas supply piping system
at test pressures in excess of 1/2 psig (3.5 kPa).
b) The appliance must be isolated from the gas supply
piping system by closing its individual manual shut-
off valve during any pressure testing of the gas sup-
ply piping system at test pressures equal to or less
than 1/2 psig (3.5 kPa).
Avoid drafts across the range. They will obstruct ventilation and
combustion.
• Never modify or alter the construction of a range by removing
leveling legs, panels, wire covers, anti-tip brackets/screws, or any
other part of the product.
• Notice: DO NOT LIFT RANGE BY DOOR HANDLE. Remove the
door for easier handling and installation. See Section 'Removing
Oven Door' in Use and Care manual.
Page 2