Publicidad
Installation
The description for installing a print server in a WLAN given in the 'Software
Quick Installation' guide does not apply to the PS54-G. Please follow the
instructions below to install a PS54-G.
This Guide describes the installation via the 'WLAN-Wizard' that is included in the
'InterCon-NetTool'. The configuration via the 'Properties' dialog or the 'Prrint
Server Homepage' is also possible.
Verify the following points before configuring the PS54-G:
You have decided into which network the PS54-G is to be integrated, and
you know the current WLAN settings.
The PS54-G is connected to a printer, and to the mains.
Refer to the Hardware Installation Guide if necessary.
The InterCon-NetTool is installed on the PC.
Refer to the 'Installing the InterCon-NetTool' section in the User Manual if necessary.
The PC is able to establish a wireless connection.
Proceed as follows:
1. Adapt the WLAN settings of the PC to the current print server settings to
communicate with the PS54-G. The PS54-G ships with the following default
settings.
Mode: Ad-Hoc
SSID: SEH
Channel: 3
2. Start the InterCon-NetTool and find the PS54-G in the print server list.
Refer to the 'InterCon-NetTool' section in the User Manual if necessary.
3. Highlight the PS54-G in the print server list and start the WLAN Wizard via
the context menu.
4. Follow the instructions of the WLAN Wizard.
• Manually enter an IP address or select a method to automatically assign the
IP address.
• Optionally the Wizard asks for a temporary IP address.
The temporary IP address is needed for configuration purposes; it does not need to be
identical to the final IP address. The temporary IP address must be within the IP
address range of the configuration PC.
Hardware Installation Guide
The current print server settings can be seen at
any time on the status page. To print a status
page press the status button on the print server.
19
Publicidad
