teutonia Fun System Manual De Instrucciones página 13

Adjusting the footrest
Using the 5-point harness
WARNING: Always use the crotch strap in
combination with the waist belt.
Attaching points (D-rings) for a separate belt harness are
provided at the outer ends of the waist restraints.
Adjusting the restraints
Shoulder restraints
Waist restraints
Crotch restraints
Raise the footrest and allow
the bar to click into place at
the marked notch. When
releasing it, hold the bar in the
centre of the latching notch
and raise the footrest.
You can position the shoulder
harnesses at 3 levels.
Always use the position
closest to the shoulder level of
your child.
Open the harness by pressing
both sides of the buckle
latches as shown in Fig. 1. It is
not necessary to separate the
chest restraints from the waist
restraints. Sit your child in the
stroller, move both its arms
through the harness opening
and insert the buckle latch in-
to the crotch belt latch.
tighten loosen
Using the Reclined Surface Extension
(available as an accessory)
If you need to, you can attach the washable bed extensions
at the foot of the sports buggy inlay using the push locks.
Safety bar
Push the insert pieces on the safety bar through the slots in
the seat cover into the receptacles beneath, which are lo-
cated in the armrests. Make sure that the safety bar has cli-
cked into place on both sides. To remove it, press the
release buttons on the insert pieces. In order to make it ea-
sier for your child to get in and out, it suffices to release and
fold up one side of the bar.
Special features of the model variations
the brake lever.
Note: The brake should only be used to slow the wheels,
not to block them.
Warning: When reordering rear wheels, please ensure that
the supplier is aware of the deceleration brake as the bra-
ke requires a special brake disc. The foot brake will not
function if the wrong brake disc is used!
FUN SYSTEM
Models with deceleration
brake:
You are able to control the de-
celeration brake using the bra-
ke on the handlebar. The bra-
king action can be fine-tuned
using the adjustment screw on
INT
13