S&P TD-350/100-125 SILENT ECOWATT Manual De Instrucciones página 9

ENGLISH
This instruction manual contains important infor-
mation and must be read carefully by competent
persons prior to any handling, transport, inspec-
tion or installation of this product. Every care has
been taken in the preparation of the instructions
and information; however, it is the responsibility of
the installer to ensure the system complies with
relevant national and international regulations,
especially safety. The manufacturer, Soler & Palau
Sistemas de Ventilación S.L.U. accepts no respon-
sibility for breakages, accidents or any inconven-
ience caused by failure to comply with the instruc-
tions contained in this manual.
The fan units referred to in this manual have been
manufactured in accordance with rigorous quality
control and International standard ISO 9001. Once
the product has been installed, this manual to be
retained by the end user.
TRANSPORT AND MANIPULATION
The packaging used for this fan unit has been de-
signed to support normal transporting conditions.
The fan unit must always be transported in its
original packaging as not doing so could deform or
damage the product. Do not accept delivery if the
fan is not in its original packaging or shows clear
signs of having been damaged.
The product should be stored in a dry place in its
original packaging, protected from dust and dirt
until it is installed in its fi nal location.
Do not place heavy weights on the packed product
and avoid impact damage.
Any lifting equipment must be safe and of suitable
capacity for weight and size. Special attention may
be required to ensure fan assembly does not dis-
tort or tilt as weight distribution may vary. Never
lift a product by pulling it by the wires or terminal
casing. Likewise, no pressure should be applied
on the propeller, turbine or safety grid while ma-
nipulating the product.
STORAGE
Storage must be in a safe, fl at, controlled environ-
ment to prevent damage, especially from water, sand,
dust, moisture, corrosion, temperature. Recommend
that duct connections (infl ow and outfl ow) are closed
to avoid dust/debris entering the equipment.
These data may also apply to an installed fan, which is
not put into operation for extended period.
IMPORTANT INFORMATION
FOR THE SAFETY OF
INSTALLERS AND USERS
• Installation must be carried
out by qualifi ed persons act-
ing in accordance with all
safety precautions applicable
and as required by law, reg-
ulations and standards in the
country applicable.
• All fan units are designed
and manufactured in accord-
ance with EC Directive. Safety
guard accessories are availa-
ble from S&P if required due
to specifi c installation.
• Working ambient temperature
for fan unit equipment should
not be exceeded typically this
will be within -20°C to +40°C,
unless stated otherwise.
• This fan unit must not be used
in explosive or corrosive at-
mospheres.
• If the fan unit is to extract air
from premises where a boiler
or other combustion appli-
ance is installed, make sure
that the room has suffi cient
EN
9