Desa POWERFAST PEBNS11/4-B Manual De Instrucciones página 7

To prevent scratching the project surface, place the rubber tip protector on
the safety lock. The protector is located on the opposite side of the staple/nail
view window. See Figure 6.
Maintenance
WARNING: Do not alter this tool in any way. Only use accessories
designed for this tool.
WARNING: Never perform steps listed below while tool is plugged
in. Accidental discharge may occur. Toggle power switch to the OFF
(0) position and unplug tool.
Tool Jam
1. If tool jams, toggle power switch to the OFF (0) position and unplug tool.
2. Lay tool on its side with view window facing upward.
3. Press in latch lock and slide magazine back until fully open (see Loading
Tool, pages 5 and 6).
4. Remove unused staples/nails.
5. Remove staple(s)/nail(s) causing jam.
6. Reload tool (see Loading Tool, pages 5 and 6).
Cleaning
Use a clean cloth to remove dirt from tool. Do not use solvents when cleaning
plastic parts.
Lubrication
Do not oil or grease any part of tool. This may damage tool.
IMPORTANT: Do not attempt to repair tool or replace broken parts.
WARNING: This product contains chemicals known to the State
of California to cause cancer or birth defects, or other reproductive
harm.
116261
Rubber Protective Tip
Figure 6
7
www.desatech.com