Uline H-1225 Manual De Instrucciones página 3

Bottom
Figure 1
6
2
Figure 2
Figure 3
PAGE 3 OF 12
ASSEMBLY INSTRUCTIONS
Top
2
1
4
1
4
6
ASSEMBLING MAIN PANELS
5
NOTE: Do not tighten bolts until unit is
completely assembled.
1. Locate and separate the left and right-hand sides
(2 & 6). Identify the top of each panel. The top of
each panel has three holes instead of one.
2. Place back (1) on a protected flat surface so that
the flanges face upward.
3. Bolt left side (2) to the back (1) so that side flange
fits around back (use 7 bolts and nuts - nuts to the
inside). Do not use bottom two holes; these will be
used for attaching legs in step 7. (See Figure 1)
4. Next bolt top (4), bottom (4) and intermediate top
(4) to back and left side panel (use 4 bolts and nuts
each). Bolt an intermediate side and back panel
to the flange on the back of the first locker in seven
places. (See Figure 2)
5. Next attach a top, bottom and intermediate top
to the first intermediate side and back. These will
share bolts with the parts on either side of them as
shown in detail view. (See Figure 2)
6. Next attach the remaining intermediate side and
back panel to the flange on the back of the
second locker. Then attach remaining top, bottom
and intermediate top to the intermediate side.
(See Figure 2)
7. Attach coat hooks (5) to each locker's left side and
back panel:
• Side – 2nd, 3rd & 9th, 10th holes from top.
• Back – 2nd, 3rd & 11th, 12th holes from top.
8. Bolt right side (6) to the back so that side flange fits
around back. (See Figure 3)
0821 IH-1225