Installation; Positioning - SCHOLTES MULTIPLO.1 F Manual De Instrucciones

Installation

! Before operating your new appliance please read this
GB
instruction booklet carefully. It contains important
information concerning the safe operation, installation
and maintenance of the appliance.
! Please keep these operating instructions for future
reference. Pass them on to any new owners of the
appliance.

Positioning

! Keep all packaging material out of the reach of
children. It may present a choking or suffocation hazard
( see Precautions and tips ).
! The appliance must be installed by a qualified
professional in accordance with the instructions
provided. Incorrect installation may damage property or
cause harm to people or animals.
Built-in appliance
Use an appropriate cabinet to ensure that the appliance
operates properly.
• The supporting surface must be heat-resistant up to a
temperature of approximately 100°C.
• Avoid installing the hob above a dishwasher: if this
cannot be avoided, place a waterproof separation
device between the two appliances.
• Depending on the hob you want to install ( see figure ),
the cabinet must have the following dimensions:
Installing semi-flush hobs (MULTIPLO.1 SF)
All the necessary precautions must be taken in order
to install the appliance in conformity with current
accident-prevention regulations (CEI-UNI-CIG)
relating to gas and electrical connections. To ensure
sit-on hobs installed in kitchen cabinets operate
correctly, the minimum distances indicated should
be observed (see figure). All adjacent surfaces and
the back panel should also be able to withstand an
overheating temperature of 65°C.
12
MULTIPLO.1 SF
50 min
Securing the appliance to the cabinet
The appliance must be installed on a perfectly level
supporting surface.
Any deformities caused by improper fixing could
affect the features and operation of the hob.
• Before fitting the hob to the worktop, position the
seal provided along the perimeter of the hob, as
illustrated in the figure.
• The installation cavity should have the dimensions
indicated in the figure accompanying the previous
paragraph.
Fix the hob as follows:
1. Use the screws supplied to fit the 4 alignment
springs in the holes provided at the central point of
each side of the part underneath the hob.
2. Place the hob in the cavity, make sure it is in a
central position and push down on the whole
perimeter until the hob is stuck to the supporting
surface.
700 min
50 min