Descargar Imprimir esta página

AEG DELICATE 7000 SI7-1-4WB Manual De Instrucciones página 9

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 21
FABRIC
Denim
Please follow the instructions of your garment care label.
Varied ironing speed and fabric dampness might cause optimal setting to differ from the recommendations in the table!
TROUBLESHOOTING
PROBLEM
Soleplate is not heating even
though iron is turned on.
Iron does not produce steam.
Steam jet and vertical steam jet
function does not work.
Water leaks from the soleplate
during ironing.
Flakes and impurities come out of
the soleplate during ironing.
Water leaks from the soleplate
while the iron is cooling down or
after it has been stored.
Brown streaks come out of the
soleplate while ironing and stain
the linen.
www.aeg.com
TEMPERATURE SETTING
Cotton or
Linen
POSSIBLE CAUSE
Connection problem
Temperature control is in "Outdoor"
position.
Not enough water in tank.
Selected temperature is lower than that
specified to use with steam.
Steam jet function was used very
frequently within a short period.
Iron is not hot enough.
The iron is not hot enough.
You have used hard water, which has
caused scale flakes to develop in the
water tank. Clean the iron according to
Cleaning section.
The iron has been put in horizontal
position while there is still water in the
water tank.
You may have used chemical
descaling agents different from the
recommendation.
Fabric fibers have accumulated in the
holes of the soleplate and are burning.
Fabrics might not be properly rinsed or
the garments are new and have not been
washed before ironing.
IRONING RECOMMENDATION
Use maximum steam. Apply maximum steam by pressing and
holding the steam on/off button.
SOLUTION
Check main power supply cable, plug and
outlet.
Select higher programme like "
Fill water tank (see "Getting started", no 2).
Increase temperature to at least "
Put iron on horizontal position and wait before
using steam jet function.
Adjust the proper temperature to steam
ironing (up to "
position and wait until temperature indicator
light turns off.
Select the Cotton setting ("
maximum) suitable for steam ironing. Put the
iron on its heel and wait until the headlight is
on before you start ironing.
Press and hold the steam button for about
one minute to get steam. Then hold one more
minute in order to clean the steam generating
system. Before starting ironing, please test
your iron on an old towel to ensure that no
residues inside the iron are transferred to your
garments.
Empty the water tank.
To prevent this from happening, it is
recommended to exchange the Soft Water
Activator according to the indications.
Clean the soleplate with a damp soft cloth.
Please rinse the fabrics properly before ironing.
Cotton".
Cotton".
Cotton"). Put iron in vertical
Cotton" to
9
GB
DE
AR
ES
FR
GR
NL
PT

Publicidad

loading