Maintenance - SPORTSTECH F28 Manual De Instrucciones

11、Maintenance
Maintain the machine
Proper maintenance can always keep the machine in good condition.
1. Do not use sand paper or solvent to clean the machine.
2. Controlling parts can not be exposed in the sun or humid environment.
3. Check and tighten all parts regularly. Replace broken parts immediately.
Adjust the running belt
The running belt is well adjusted before being packed. After a period of use, the running belt may
loosen or deflect, which is normal. Then it is necessary to adjust the running belt, otherwise there
will be friction damage to the running belt.
1. Tension:
a) Keep the machine at the speed of 3km/h.
b) Put the multi-wrench into the left adjusting screw and turn clockwise by 1/4 circle.
c) Put the multi-wrench into the right adjusting screw and turn clockwise by 1/4 circle.
d) If necessary, repeat Step b and c as above until the running belt runs smoothly.
Note: These four steps are available to tighten the running belt, if you need to loosen it, please turn
anti-clockwise.
2. Deflection:
a) Keep the machine at the speed of 6km/h.
b) If the running belt deflect to the left, put the multi-wrench into the left adjusting screw and turn
clockwise by 1/4 circle or put the multi-wrench into the right adjusting screw and turn anti-
clockwise by 1/4 circle. (Diagram 1)
c) If the running belt deflect to the right, put the multi-wrench into the right adjusting screw and
turn clockwise by 1/4 circle or put the multi-wrench into the left adjusting screw and turn anti-
clockwise by 1/4 circle. (Diagram 2)
d) If necessary, repeat Step b and c as above until the running belt runs in the middle.
Deflect to the left (Diagram 1)
Lubricant (White bottle)
All treadmills were added lubricant before packed. However, it is still necessary to add lubricant
after using the machine for 30 hours or 30 days.
How to add lubricant:
a) Cut a small hole at the head of the lubricant bottle. Make sure that the lubricant can be shot out
from the hole.
b) Lift up the running belt and shoot the lubricant to the middle of the running board.
c) Put down the running belt and put some pressure on the place where you add lubricant.
d) Start the machine at the speed of 1 km/h for 1 minute.
Deflect to the right (Diagram 2)
- 15 -