Descargar Imprimir esta página

Chicco up to 5 Manual De Instrucciones página 13

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 26
d-
following steps:
a. Release the buckles of the three-points safety harness (E)
(fig. 12).
n-
b. Put the child on the booster seat, fastening them in with
the safety harnesses (fig. 13). Check that the belts and buck-
he
le are fastened properly. Adjust the length of the straps to
best fit the child's body.
7. Apply the activity tray to the chair booster seat pulling
he
outwards on the armrests (C), securing it through the cen-
ait
tral fastening pin (H) on both chair sides (fig. 14). The stabi-
ur
lisers on the sides of the central fastening pin are used to
stabilise the tray; make sure that the tray is fastened to the
central fastening pin in at least one point, and never just
er
to the stabilisers only (figure 15). The activity tray can be
adjusted to 3 positions. 
h
 
FOLDING AND TRANSPORT
Take off the child from the chair booster seat and follow
the steps below:
8. Detach the tray, pulling outwards on the relative side
will
handles as explained in point 2.
re-
9. After deactivating the lock of the roll-up straps pressing
ed
the button (P), open the buckles of the lower (I) and rear (M)
ol-
straps to remove the product from the seat (fig. 16).
10. When the product is used with different height than
the rest position, the product must be brought back to the
eat
minimum height following the indications given in point 4.
11. Close the buckles of both straps, at this point press the
D)
button to release the straps (P), placed under the chair
ck"
booster seat to correctly rewind the straps (fig. 17).
en-
12. Press the backrest release button (D), pull the backrest
est
(A) downwards bringing it completely to the closure posi-
tion (fig. 18).
s.
13. Fix the activity tray to the stabilisers (H) placing it in or-
out
der to compact it for the transport.
14. To complete the chair closure, lock the rewinding of the
ns
straps by pressing the lock button (O) (fig.19). So it is possi-
(J)
ble to use the straps for the transport of the chair avoiding
that it falls due to its weight (fig. 20).
nd
To do so, adjust the length of the straps, as needed.
.
 
ter
REMOVAL OF THE FABRIC PARTS
ht.
For a correct and proper cleaning of the chair booster seat it
sh
is possible to remove the backrest (Q) and seat (R) padding.
de
To do so follow the indications below:
15. To remove the backrest padding, release the elastics on
od-
the back of the padding (Q) (fig. 21) from the hole on the
ed
frame.
ps
16. To attach the padding (Q) follow the procedure shown
nd
in point 15 in reverse order, inserting the elastics in the cor-
ng
responding holes (fig.22).
17. To remove the seat padding (R), release the elastics on
ble
the back of the padding (R) from the hole on the seat and
fig.
remove the crotch strap (fig. 23/24).
18. To attach the fabric part of the seat pass the crotch strap
(I)
through the slot on the padding and follow the procedure
ed
shown in point 17 in reverse order.
1).
 
fit-
not
est
he
WARNING USE 36-60 m
IMPORTANT! KEEP FOR FUTURE
REFERENCE.
WARNING: BEFORE USE, REMOVE
AND DISPOSE OF ALL PLASTIC BAGS
AND PACKAGING MATERIALS AND
KEEP THEM OUT OF REACH OF CHIL-
DREN.
WARNINGS
• WARNING: This product is de-
signed for children of 36 to 60
months, maximum weight 23 kg.
• WARNING: To use the chair
booster seat with children over 36
months, remove the safety harness
(bringing it back in the correspond-
ing compartments under the seat
padding) and the rear backrest.
• WARNING: Check that the fasten-
ing systems of the seat are properly
mounted and adjusted before use.
• WARNING: Always check the se-
curity and the stability of the chair
mounted seat on the adult chair
before use.
• WARNING: Do not use this chair
mounted seat on stools or bench-
es.
• WARNING: Use the chair booster seat
in the lowest configuration: the legs
shall not be extracted.
• The
minimum
adult's chair dimensions when us-
ing this product are: Seat width 370
mm; Seat depth 350 mm; backrest
height 215 mm.
• Ensure that the adult chair with the
chair booster seat is placed in a po-
sition where the child is not able
to use its feet to push against the
table or any other structure as this
can cause the tip over of the adult
13
recommended

Publicidad

loading