9. CONT./SINGLE-BUTTON
For choosing single playback or continous play. By pressing this button once, the display shows „SINGLE".
The current track is then played once and the player goes into Pause-mode.
10. TIME-BUTTON
The display can be switched from track playback time (Elapsed) to total remain time (Total Remain) to track
remain time (Remain).
While playback of a track or a program the display shows the track playback time (Elapsed).
Press this button once and the display shows the total remain time (Total Remain).
Press this button once more and the track remain time (Remain) is displayed.
11. PROGR.-BUTTON
For programming the desired tracks.
12. CUE-BUTTON
Pause-mode:
In the pause-mode, you can cue by pressing and holding the Cue-button. As soon as you let the Cue-button
loose, the player returns to the track-start or the Cue-point.
Playback-mode:
If you press the Cue-button during playback, the player returns to the track-start or the Cue-point and goes
into Pause-mode.
13. PITCH-BUTTON
Press the Pitch-button in order to adjust the playback speed by ± 10 % (red LED illuminated).
14. PITCHFADER
You can adjust the desired speed with the Pitchfader after pressing the Pitch-button. The display shows the
current percentage. If the Pitch-button is not pressed, any adjustment on the Pitchfader will have no effect.
15. PITCH BEND-BUTTONS
The player must be in the playback mode. The playback-speed can temporarily be changed by +/- 16 %.
16. RELAY-BUTTON
By pressing the RELAY-button, the playback automatically switches to the other player after every track.
Please refer to 6.8 Relay-operation.
Rear panel:
17. CONNECTOR PORT
Connect the Dual CD-Player here.
18. CONTROL-SOCKETS
Via the Control-socket, the respective CD-player can be remotely controlled. If you are using a mixer with
Faderstart-function connect the player with the Control Out-socket. Please note that these sockets must
never be connected with any voltage. Please refer to 6.9 Faderstart.
22/48
1060225E_V_1_0.DOC