Omnitronic CDP-386 Manual Del Usuario página 24

6.5 SYNCHRONISATION WITH THE PITCH BEND BUTTONS
You can synchronise the two CD players while cueing with the headphones via the mixer.
Method:
Press the Play/Pause-button of player 1.
Press the Play/Pause-button of player 2.
Use your headphones for cueing.
Only use the Pitch Bend-buttons of Unit 2.
If you stop pressing the buttons, the player returns to the original speed.
6.6 PROGRAMMING
Create a program:
Press the Prog.-button.
Press one of the Skip-buttons and the display will show the desired track number. Press the Prog.-button in
order to save the track.
Press one of the Skip-buttons again in order to choose the next track.
Continue programming like this until you have no more songs to program or the maximum of programmable
songs (20) is reached.
Check the program:
You can interrupt the programming procedure in order to check the program by pressing the Prog.-button
once more after you entered a track. Press the Prog.-button repeatedly and the display will show the order of
programmed songs.
Read a program:
After entering your last song, press the Play/Pause-button. The program will be played back.
Delete a program:
In order to leave the program mode press the Prog.-button and hold it for approx. 3 seconds or open the CD
tray or switch the device off.
6.7 CUEING
Auto-Cue function:
After switching on or after pressing the Skip-buttons, the player automatically jumps to the section where the
music starts. This fuction enable to minimize the transitions between two tracks.
Back-Cue function:
If you press the Cue-button during playback, the player returns the position where the playback started and
goes into Pause-mode.
Memorizing the Cue-point:
Possibility 1:
The player is in Playback-mode.
Press the Play/Pause-button and the player goes into Pause-mode.
Press the Play/Pause-button and the player goes into Playback-mode. The Cue-point was memorized at the
position where you started the playback.
As soon as you press the Cue-button, the player returns the Cue-point and goes into Pause-mode.
Possibility 2:
The player is in Playback-mode.
Press the Play/Pause-button and the player goes into Pause-mode.
Select the Cue-point via the Search/Scan-buttons. The display shows the starting-point (e.g. 3:42 22).
Press the Play/Pause-button and the player goes into Playback-mode. The Cue-point was memorized at the
position where you started the playback.
As soon as you press the Cue-button, the player returns the Cue-point and goes into Pause-mode.
24/48 1060225E_V_1_0.DOC