Installation; Indicator Of Temperature; Coldest Zone; Before Using Your Refrigerator - Sharp SJ-FS810V Manual De Manejo

INSTALLATION

WARNING
■ Do not install the refrigerator in a damp or wet location as
this may cause damage to the insulation and a leakage.
Condensation may also build on the outer cabinet and
cause rust.
1
Keep adequate ventilation space around the refrigerator.
• The fi gure shows the minimum
required space for installing the
refrigerator. The measurement
condition of power
consumption is conducted
under a different space
dimension.
• By keeping greater space,
the refrigerator may be operated
under a less amount of power
consumption.
• If using the refrigerator in the smaller space dimension
than the below fi gure, it may cause the temperature rise
in the unit, loud noise and failure.
• The space between the rear of the refrigerator and the
wall should be 60mm or more and less than 75mm.
If the space is wider than 75mm, you may get injured by
touching compressor and its peripheral parts which are
extremely hot during the operation.
Overall space
required in use
2
Use the two front adjustable feet, to ensure that the
refrigerator is positioned fi rmly and fl at on the fl oor.

INDICATOR OF TEMPERATURE

This refrigerator is provided with an indicator of temperature in the refrigerator compartment to allow you to control the average
temperature in the coldest zone.

Coldest zone

The symbol indicates the coldest zone in the
refrigerator compartment.
(The door pocket positioned at the same height isn't
the coldest zone.)
Checking the temperature in the coldest zone
You can carry out regular checks to ensure the temperature
in the coldest zone is correct and, if necessary, adjust the
refrigerator temp. control.
To maintain a correct temperature inside the appliance, check
that the indicator of temperature is always BLUE.
If the indicator of temperature turns WHITE, the temperature
is too high; in this case, increase the refrigerator temp. control
setting and wait for 6 hours before checking the indicator of
temperature again.
90mm
or more
60mm 60mm
or more or more
1500 mm
Adjustable foot
Symbol
3
When right and left doors are not properly aligned, adjust
using the adjustable feet.
When the left door is
raised.
Lower the foot
at right side.
(Until the adjustable foot on the
other side is slightly off-ground.)
4
Remove the 4 screws of the cabinet lower part, and then set
the foot cover (supplied inside the refrigerator compartment)
with removed 4 screws.
Screw
(4 screws)
NOTE
• Position your refrigerator so that the plug is accessible.
• Keep your refrigerator out of direct sunlight.
• Do not place next to heat generating appliance.
• Do not place directly on the ground. Provide suitable stand.
• To insert the power plug when the door is opened, door alarm
sounds but it is not abnormal. This sound stops when closing the
door.

Before using your refrigerator

Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
BLUE
Correct setting
NOTE
• The internal temperature of the refrigerator depends on various
factors such as the ambient temperature of the room, the amount
of food stored and the frequency of door opening.
• When fresh food has been introduced or the door has been left
open for some time, it is normal for the indicator of temperature to
turn WHITE.
Free standing type
When the right door
is raised.
Lower the foot
at left side.
Screw
Foot cover
WHITE
Temperature too high,
adjust the refrigerator temp.
control.
5