Frontal Panel Description - Perle MP2-POOL-T Manual De Regulatión

ENGLISH

FRONTAL PANEL DESCRIPTION

GENERAL FUNCTIONS OF THE PUMP :
- DOSING TIME REGULATION
- FLOW RATE REGULATION
- START UP DELAY (30 minutes , unmodificable)
- DEFAULT PARAMETER RESTORING
- DOSING ENABLE CONTROL
- LEVEL CONTROL
- STOP DOSING ( STAND_BY )
- PRIMING FUNCTION
- FUNCTION FOR THE VISUALIZATION OF THE PROGRAMMED PARAMETERS
nA : 8 daily dosing
tA: 30 minutes (total daily dosing time)
FL: FS maximum pump flow rate
START UP DELAY: 30 minutes (unmodificable), this is the time that the pump waits, after the receiving of the
enable input signal, before beginning the first daily dosing.
Description of the default pump functioning:
After the receiving of the enable input (recirculation pump is swiched on) , the pump waits 30 minutes (delay start)
before the first daily dosing. The pump will dose 8 times (=nA) during the day with fixed intervals of time of 1 hour.
Each dosing will be of 3 minutes and 45 seconds (=tA : nA), at the maximum flow rate (FL=FS). After 8 hours from the
first dosing the pump ends the daily cicle and waits for a new enable signal input.
DEFAULT SETTINGS RESTORE
PUMP'S CONNECTIONS
Rev 1.0
1.Display: 2 digit , 7 segments
2.Red Led: ▪ fix lighted = enable input is ON
3. OK/SbY button: ▪ puts the pump in stand_by mode
4. SET button: ▪ allows to navigate through the menu
DEFAULT SETTINGS
Push and release together OK/SbY and SET buttons.
The display will show "r S" (reset) and all the default parameters are
restored in memory. The pump will go in the Ready state during which it
waits for the enable input. All the default settings are restored in
memory. After the receiving of the enable input (recirculation pump is
swiched on) , the pump waits 30 minutes (delay start) before the first
daily dosing.
A – Power cable, 230 V- 50Hz (upon request : 115 ~ )
B – Enable input cable, 230 V- 50Hz (upon request : 115 ~ )
C – ON-OFF switch OPTIONAL
D - Level probe connector (3 and 4 contacts). OPTIONAL
Cod. 00.008.565
▪ switched off = enable input is OFF
▪ blinking = pump is dosing
▪ saves the changes
▪ Modifies the parameters values
▪ Visualies the parameters values
5