Kohler REVIVAL K-2001 Instrucciones De Instalación página 5

INSTALLATION K-2000-*, K-2002-*:
Rough-in the supplies and drain piping according to the
roughing-in dimensions illustrated, see Pages 2 and 3.
NOTE: Control stop handle when in full open position
must not extend more than 7" (17.8cm) from finished wall.
Install sufficient backing behind the finished wall for
anchoring devices.
For K-2000-*: locate the pedestal mounting hole 15-1/8"
(38.4cm) from the finished wall and on the centerline of
the lavatory.
NOTE: Do not drill floor anchor hole for pedestal at this
time.
For K-2002-*: locate the pedestal mounting hole 12-3/16"
(31cm) from the finished wall and on the centerline of the
lavatory.
NOTE: Do not drill floor anchor hole for pedestal at this
time.
For K-2000-* or K-2002-*: apply eight of the
self-adhesive gaskets (provided) on the top edge of the
pedestal.
NOTE: These gaskets may need to be repositioned as
necessary to improve fit.
Place pedestal on centerline in approximate location.
Carefully place the lavatory over the pedestal.
Move the pedestal slightly as required to ensure proper fit
and centering in the recess on the bottom of the lavatory.
Check the level of the lavatory.
NOTE: The lavatory must be supported by the pedestal.
Make sure the lavatory is centered.
A
1007269-2-
FINISHED WALL
15-1/8"
(38.4cm)
FINISHED WALL
12-3/16"
(31cm)
K-2000-*
5
Fig. #4
Fig. #5
K-2002-*
Fig. #6
Kohler Co., Kohler, WI, U.S.A.