Cub Cadet Z-Force S 60 Manual Del Operador página 10

Install Operator's Seat
To install the seat proceed as follows:
NOTE: The seat is shipped with the seat switch and seat
pan attached.
1. Cut any straps securing the seat assembly to the tractor.
Remove any packing material.
NOTE: Be careful not to cut the wiring harness connecting
the seat and the seat switch.
2. Remove the two shoulder screws and flange lock nuts in
the seat bracket as shown in Figure 3-3.
3. Rotate the seat into position and secure the seat into place
with the previously removed shoulder screws and flange
lock nuts. Be careful not to crimp or damage the wire
harness while installing the seat. See Figure 3-4.
NOTE: Be sure to push the excess wire from the wire
harness into the seat box hole before continuing.
10 S 3 — A
ection SSembly
Figure 3-3
Figure 3-4
& S -U
et p
Lower Deck Discharge Chute Deflector
WARNING!
Never operate the mower deck
without the chute deflector installed and in the
down position.
The discharge chute deflector must be installed before operating
the mower. To install the chute deflector, proceed as follows:
1. Remove the carriage screws and flange lock nuts installed
on the mounting bracket on the deck. See Figure 3-5.
Figure 3-5
2. With the previously removed hardware, install the chute
deflector on the deck as shown in Figure 3-5.
Adjusting the Seat
1. To adjust the position of the seat, push the seat adjustment
lever to the left. See Figure 3-6.
2
Figure 3-6
2. Slide the seat forward or rearward to the desired position;
then release the adjustment lever. Make sure seat is locked
into position before operating the tractor. See Figure 3-6.
1