Assembly & Set-Up - Cub Cadet Z-Force S 60 Manual Del Operador

Assembly & Set-Up
NOTE: This Operator's Manual covers several models. Tractor
features may vary by model. Not all features in this manual are
applicable to all tractor models and the tractor depicted may
differ from yours.
NOTE: All references in this manual to the left or right side and
front or back of the tractor are from the operating position only.
Exceptions, if any, will be specified.
Tractor Preparation
Manually Moving the Tractor
1. Engage the transmission bypass rods, one on each side of
the tractor, to move the tractor manually without starting it.
The transmission bypass rods are located on the rear of the
tractor, just inside each rear wheel. Engage the bypass rods
by pulling each one out (a) and to the right (b) to lock it into
place. See Figure 3-1.
a
Figure 3-1
2. Disengage the bypass rods by reversing steps a & b after
moving the tractor. See Figure 3-1.
3. Remove the deck wash system nozzle adapter from the
manual bag and store for future use.
Steering Wheel Column
The steering wheel column is tilted all the way back for shipping
purposes. To tilt the column forward, rotate the steering column
adjustment lever counterclockwise, place the column in the desired
position and then rotate the lever clockwise to secure the column in
place. See Figure 3-2.
NOTE: Be sure that the steering column adjustment lever is
tight to prevent the column from moving when operating
the machine.
b
Steering Column
Adjustment Lever
Figure 3-2
3
9