Beaba BIB EXPRESSO BEA0206 Manual Del Usuario página 12

STARTING UP OF APPLIANCE
1- Place the heating unit on the arch support :
2- Plug the appliance into an earthed 220-240V socket.
3- Place the power cable at the rear passing it through the
groove as shown on picture 10
4- Before the 1st use, launch a Bain Marie cycle to rinse the
heating unit:
- Pour 200ml of water into the unit
- Close the lid and press the button (
Beep and back lighting of button flashes.
- When the cycle is over, you hear 3 beeps and back light
switches off. Put any big cup over 200ml on the baby bottle receptacle
- Push the water lever downwards to empty the heating unit.
RISK OF BURNING
- Wait for unit to cool down a few minutes before using the appliance.
INSTANT PREPARATION MODE
Instant preparation mode is the fastest mode for preparing bottles. You only need
a few seconds to obtain a bottle at the selected temperature.
1. Fill the bottle with the amount of water for the volume of the preparation
required.
2. Open the lid #1 and pour water into the empty heating unit #2
3. Close the lid#1
4. Fill the bottle with the amount of milk formula for the volume of the preparation
required and put the bottle in the centre of the receptacle #8
5. Select a temperature button. You will hear a beep and the button will flash
during the heating process.
6. As soon as the water has reached the correct temperature, the appliance
beeps 3 times and the button's light switches off.
7. Push the water lever#4 downwards until the bottle is full.
8. Use a clean cloth to remove any water remaining in the bottom of the heating
unit (...) before storing your appliance.
Note : For hygiene reasons and in order to avoid all microbiological risks, the
bottle must be consumed quickly after preparation (within two hours).
). You will hear 1
due to hot water being released.
12
BE CAREFUL,
Water
Water
Water
* heat
** mixi
BAIN
The ba
mode
are he
of prep
• Mod
sma
• Mod
larg
1. O
2. F
3. P
4. S
th
5. A
b
B
6.
a
7. C
8. A
th
y