Troubleshooting Guide - Bellman & Symfon Visit 868 Bridge Manual De Instrucciones

103
Troubleshooting
You can carry out a number of checks yourself before sending a product for repair.

Troubleshooting guide

Problem
Nothing happens when the transmitter is activated
with the test button.
The LED (1) blinks yellow when the Bellman Visit
868 Bridge is activated.
Solution
• Check that the power supply unit is connected
correctly.
• If the power supply unit is not connected, change
the back-up battery. Only use alkaline 6LR61 or
lithium 6F22 type batteries.
Make sure that the power supply unit is connected
correctly.
• Check that all the connections are correct.
• Change the back-up battery. Only use an alkaline
6LR61 or lithium 6F22 type battery.
Make sure that the power supply unit is connected
correctly.
Problem
The LED (1) blinks green when the Bellman Visit
868 Bridge is activated but the receivers are not
responding.
One of the systems is working but the other one is
not working.
The receiver emits a strange alarm when activated
by the Bellman Visit 868 Bridge.
The receiver signals when no transmitter is
activated.
Solution
• Check the batteries in the receivers.
• Check that the receivers are not placed too far
away by moving them closer to the Bellman Visit
868 Bridge.
• Check that all units in the Bellman Visit 868 and
Bellman Visit Systems are set to the same Radio
Key. For further information see Appendix/Further
information/Settings/Radio Key.
• Check that all units in the Bellman Visit 868 and
Bellman Visit Systems are set to the same radio
key. For further information see Appendix/Further
information/Settings/Radio key.
• Set the Signal Switch to 0000.
• Change the Radio Key on all units in the relevant
Bellman Visit 868 System. There is probably another
system nearby with the same Radio Key.
104