Mounting The Solar Cell; Preparing The Product For Use; Switching The Motion Detector On And Off; Setting The Lighting Duration - LIVARNO LUX HG02109A Instrucciones De Montaje

Unscrew hinge joint
bracket from the spotlight
3
Utilize the mounting bracket
for making the position of the two outer drill
holes.
Then drill these holes and attach the mounting
bracket using the supplied dowels
3
screws .
2
Now attach the spotlight
bracket using the previously removed hinge
3
joint , spring washer
4
Please make sure that the spring washer
and flat washer
6

Mounting the solar cell

Make sure you will not be drilling into electrical,
gas or water lines inside the wall. Use a power drill
to drill the holes into the brick wall. Always observe
all safety instructions for the power drill in the ma-
nual for the power drill. Death or injury due to
electric shock may otherwise result.
When selecting the mounting location for the solar
cell , pay attention to the following:
12
The solar cell needs to be as directly
12
exposed to sunlight as possible. Even partial
shading of the solar cell
have a significant influence on charging.
Cardinal direction:
Orientation towards the south is optimum. Orienta-
tions with slight deviations towards the west are
preferable to those with slight deviations towards
the east.
Horizontal orientation:
The horizontal orientation of the solar cell depends
on the geographic latitude of the mounting loca-
tion. In central Europe, and angle of 30°–40° is
ideal.
A mounting plate with 6 drill holes for screws is
located at the back of solar cell
Mount the solar cell
tion using the 4 small screws
. Depending on the topography of the
15
to detach the mounting
4
.
10
as a template
3
and
1
to the mounting
10
and flat washer
5
5
are located as fig A.
during the day can
12
.
12
at the designated loca-
12
and dowels
13
mounting location, you can freely choose 4 of
the drill holes in the mounting plate; however,
you should ideally select 2 drill holes on the
right and left each (see fig. B).
Then lay the solar cable plug
the plug to the solar electricity socket
spotlight .
10
The solar cell
plate via a swivel joint. Orient the solar cell
in a manner that ensures maximum exposure to
. sunlight.
6

Preparing the product for use

Switching the motion detector
on and off
Press the ON / OFF switch
sition to switch on the motion detector
Press the ON / OFF switch
sition to switch off the motion detector

Setting the lighting duration

Turn the rotary control TIME
of the motion detector
the duration of the illumination. The lighting
duration can be adjusted within a time window
of approx. 5s +/-2s to 5 min +/-1min.
Adjusting the sensitivity of
the sensor
Turn the rotary control SENS
of the motion detector
crease the sensitivity of the sensor.
Note: The motion detector responds to heat
radiation. When outdoor temperatures are low,
it is more sensitive to body heat than when out-
door temperatures are warm. Be sure to regu-
late the sensitivity of the sensor over the course
of the year.
and connect
14
is connected to the mounting
12
into the ON po-
11
into the OFF po-
11
on the bottom
18
clockwise to increase
9
on the bottom
17
clockwise to in-
9
GB/MT
of the
8
12
.
9
.
9
33