Kohler Fleur K–2119 Manual Del Usuario página 5

2. Install the Lavatory
Drill 1/4" mounting holes at the marked locations on the finished
wall.
NOTE: You can also use other fastening devices of sufficient size
and strength.
Install hanger bolts to the backing material so each bolt extends past
the finished wall between 1-3/4" (4.4cm) and 2-3/16" (5.6cm).
Install the faucet and drain to the lavatory according to the
manufacturer's instructions.
Move the pedestal in front of the drilled hole in the floor, and
carefully set the lavatory on the pedestal so the hanger bolts extend
through the lavatory anchoring holes.
CAUTION: Risk of product damage. Do not overtighten the
nuts. Overtightening may damage the product.
Install a rubber washer, followed by a metal washer and nut onto
each hanger bolt. Level the lavatory, and carefully tighten the nuts
until snug.
Position the clip in the hole in the back of the pedestal, and secure
the pedestal to the floor with the lag bolt. Carefully wrench tighten,
but do not overtighten.
Connect and tighten the trap to the drain, and complete the water
supply connections to the faucet according to the instructions
packed with the faucet.
Kohler Co. 5 1016190-2-A