Grounding Instructions - Invacare IRC607 Manual Del Usuario

After any adjustments, repair or service and before use, make sure that all attaching
component parts are secure.
Regulatory Listing In Compliance With:
UL 1431- Personal Hygiene and Health Care Appliances
CSA C22.2 No. 68 - Motor Operated Appliances

Grounding Instructions

Improper use of the grounding plug can result in a risk of electric shock.
NOTE: For this procedure, refer to FIGURE 1.
NOTE: This product should be grounded. In the event of an electrical short circuit, grounding
reduces the risk of electrical shock by providing an escape wire for the electrical current. This
product is equipped with a cord having a grounding wire with a grounding plug. The plug must
be plugged into an outlet that is properly installed and grounded.
NOTE: If repair or replacement of the cord or plug is necessary, do not connect the grounding wire
to either flat blade terminal. The wire with insulation having an outer surface that is green with or
without yellow strips is the grounding wire.
NOTE: This product is for use on a nominal 120 V circuit, and has a grounding plug that looks
like the plug illustration in SKETCH A of FIGURE 1. A temporary adapter, which looks like the
adapter illustrated in SKETCHES B and C, may be used to connect this plug to 2-pole receptacle
as shown in SKETCH B if a properly grounded outlet is not available. The temporary adapter
should be used only until a properly grounded outlet (SKETCH A) can be installed by a qualified
electrician. The green colored rigid ear, lug and the like extending from the adapter must be
connected to a permanent ground such as a properly grounded outlet box cover. Whenever the
adapter is used, it must be held in place by the screw.
NOTE: Check with a qualified electrician or serviceman if the grounding instructions are not
completely understood, or if in doubt as to whether the product is properly grounded.
SKETCH "A"
Grounded Outlet
Grounding
Plug
Part No 642661
WARNING
SAVE THESE INSTRUCTIONS
WARNING
SKETCH "B"
2 Pole
Receptacle
FIGURE 1 Grounding Instructions
3
Temporary
Temporary
Adaptor
Adaptor
Metal
Screw
SKETCH "C"
Tab for Metal Screw
50 PSI Compressor