Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5. Attach the nebulizer tubing to the outlet port.
6. Turn the ON/OFF switch to the ON
position.
WARNING
Use only the pressure setting directed
by your physician or qualified healthcare
professional.
1. Turn the pressure control knob
clockwise to adjust the pressure to the
setting specified by your physician's
instructions.
NOTE: The pressure gauge needle will vibrate.
Adjust the pressure gauge setting as closely as
possible to the specified pressure.
2. Proceed with therapy per physician's
instructions.
Cleaning/Replacing The Air Filters
NOTE: For this procedure, refer to FIGURE 2.
NOTE: Check the filters at least once each month. If the compressor begins to lose pressure in
normal use, check the air filters.
1. Remove the filter cap from the Inlet Filter Assembly.
2. If the foam filter appears dirty, wash with mild detergent and water. Rinse thoroughly
and let air dry.
DO NOT wash the felt filter. Water damages the felt filter.
3. Replace the felt filter if it appears dark in color, becomes clogged, or is damaged.
DO NOT operate this compressor without filters installed.
Accessories
DO NOT use the compressor for continuous operation more than 10 hours, this can
result in overheating and damage to the compressor.
J-Tube and DISS Connector for large volume nebulizer.
Part No 642661
Pressure
Gauge
Pressure
Control
Knob
Inlet Filter
Assembly
FIGURE 2 Operation
CAUTION
WARNING
WARNING
5
Outlet
Power
Port
Cord
On/Off
Switch
Suction Feet
50 PSI Compressor
Publicidad
Tabla de contenido
