Silampos StarTwist Instrucciones De Uso página 31

- INSTRUCTIONS FOR REPLACING THE CONTROL SYSTEM -
To remove the control system
- Turn the lid inwards and unscrew the
1
hexagonal nut counter clockwise
wrench nº17 (fig.08). Remove the nut.
2 - Turn the lid towards the outside and remove
the control system by pulling it out of the lid
(fig09)
Apply the new system:
- Make sure that the claws are always firmly
3
positioned against the lid (closed position) (fig10)
4
- Turn the open/close button to the
closed position
- Align the positions according to the
5
arrows in Fig10, making sure that the hole
in the control system matches the position
of the safety valve (fig10.2)
6
- Keep the claws always firmly against
the lid and fit the new control system
into the lid hole, ensuring that it fits
well (fig10).
7
- Turn the lid inwards, ensuring that the control
system remains firmly against the lid.
8 - Apply the hexagonal nut and tighten it clockwise
with wrench nº17 (fig08). Make sure it is tight
– until you cannot turn the wrench anymore.
9
- Turn the lid to the outwards.
10 - Lift the lid with one hand, and with the other,
test the opening / closing button before using
the lid. It should rotate in both directions,
without difficulty, with a click at each
limit(fig11).
The lid is ready to use.
using a
(fig10.1)
a
| 29 |
Fig. 10.1
a
Fig. 10.2
claw
nut
Fig. 08
Fig. 09
claw
Fig. 10
Fig. 11