Changing The Battery - CRATONI Rearlight Modo De Uso

• To replace this battery, use a small slotted screwdriver to remove the LED light's glass
diffuser at the lever slots provided at the top and bottom (Fig. E3).
• Then remove the battery by using a screwdriver to push out the button cell to the side
and replace it with a new one. Repeat this for the second battery too.
• Carefully push the circuit board and the glass diffuser back into the helmet holder(Fig.
E2).
USER INSTRUCTIONS: LED REAR LIGHT [G]
1. BEFORE USING IT FOR THE FIRST TIME
Remove the safety strip from the LED rear light before using it for the first time.
2. REMOVING AND ATTACHING THE REAR LIGHT
2.1. REMOVING THE REAR LIGHT
Use a small slotted screwdriver to lever out the light at the left edge (Fig.G1).
2.2. ATTACHING THE REAR LIGHT
Place the rear light in the provided mould and apply pressure to the left and right to fix it in
the holder (Fig.G2).
3. FUNCTIONS
The LED rear light has three different functions that can be used as you like.
Press once: Permanent light
Press twice: Flashing light

4. CHANGING THE BATTERY

The LED rear light is already equipped with two LR 1130
(1.5V) batteries at the time of purchase.
• Remove the rear light from the helmet (see point 2.1).
• Inside the rear light there are two button cells, push them out of the holder. The new
batteries can now be inserted.
• Put the housing back together and screw it down.
• Reinsert the rear light in the helmet (see point 2.2).
Press three times: Chase light
Press four times: Light off
Battery type: LR 1130 (1,5V),
LED class 1
9