Operating Instructions - Flex L 3709-115 Instrucciones De Funcionamiento Originales

Operating instructions

WARNING!
Before carrying out any work on the angle
grinder, always pull out the mains plug.
Before switching on the power tool
Unpack the angle grinder and check that
there are no missing or damaged parts.
Switching on and off
Brief operation without engaged
switch rocker:
Push the switch rocker forwards and

hold in position.
To switch off the power tool, release

the switch rocker.
Continuous operation with engaged
switch rocker:
Push the switch rocker forwards (1.) and

engage by pressing the front end (2.).
20
L 3709 -115, L 3709 -125, LE 9-10 125, L 10-10 125, L 801, L 1001
To switch off the power tool, release

the switch rocker by pressing the rear
end.
NOTE
Following a power failure, the switched on
power tool does not restart.
Speed preselection
(LE 9-10 125 only)
To set the operating speed, move the dial
to the required value.
Safety guard
(L 3709-115, L 801, L 3709-125)
WARNING!
Never work without the safety guard.
The angle grinder is adapted to the job with
the safety guard which can be adjusted
without a tool.
A special cutting guard must be used
for cutting.
CAUTION!
Risk of injury! Wear protective gloves.
Pull out the mains plug.
