Cequent Performance Products 76170 Instrucciones De Instalación página 6

2. Remove bumper fascia - (a) use panel removal tool to remove (2) plastic rivets from bottom center fascia. For model with hands-free liftgate, there will be (6) plastic rivets. (b) use
phillips screwdriver to remove (3) screws from wheel well liner each side. (c) open the trunk and use 3/16'' or 5 mm hex bits to remove (2) flat head screws each side. (d) using plastic
trim tools, gently remove the plastic fascia starting at the outer edges near the wheel wells. (e) disconnect the wiring from fascia each side if present.
Model with hands-free liftgate
Model without hands-free liftgate
(a)
(a)
(d)
(b)
(c)
(e)
©2017 Cequent™ Performance Products, Inc. - Printed in Mexico Sheet 6 of 24 76170NP 06-01-17 Rev. A