Cleaning And Maintenance - Ferm JSM1025P Traducción Del Manual Original

● Draw a line to define the direction in which to
guide the saw blade.
● Firmly hold the machine by the grip.
● Set the sawing speed.
● Set the mitre angle.
● Set the pendulum position.
● Switch on the machine.
● Wait until the machine has reached full speed.
● Place the saw shoe on the workpiece.
● Slowly move the machine along the pre-drawn
line, firmly pressing the saw shoe against the
workpiece.
● Do not apply too much pressure on the
machine. Let the machine do the work.
● Switch off the machine and wait for the
machine to come to a complete standstill
before putting the machine down.

CLEANING AND MAINTENANCE

3
Before cleaning and maintenance,
always switch off the machine and
remove the mains plug from the mains.
● Regularly clean the housing with a soft cloth.
● Keep the ventilation slots free from dust and
dirt. If necessary, use a soft, moist cloth to
remove dust and dirt from the ventilation slots.
● Regularly clean the saw blade to avoid
inaccuracies during use.
● Regularly lubricate the guide roller.
Replacing the saw blade (fig. B)
Worn or damaged saw blades must be replaced
immediately.
2
Only use sharp and undamaged saw
blades.
● To remove the old saw blade (14), proceed as
described in the section „Mounting and
removing the saw blade".
● To mount the new saw blade (14), proceed as
described in the section „Mounting and
removing the saw blade".
WARRANTY
Consult the enclosed warranty terms.
8
ENVIRONMENT
Disposal
The product, the accessories, and the packaging
must be sorted for environmentally friendly
recycling.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.