Electrical Safety; Vibration Level - Ferm JSM1025P Traducción Del Manual Original

Kickback is usually caused by:
- unintentionally touching hard objects or
materials with the rotating saw blade;
- a blunt saw blade;
- a saw blade that is not properly mounted;
- sawing into a previous cut;
- a lack of attention to the operation;
- an instable stance.

ELECTRICAL SAFETY

3
Always check that the voltage of the
power supply corresponds to the voltage
on the rating plate.
● Do not use the machine if the mains cable or
the mains plug is damaged.
● Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm . If you use a extension
2
cable reel, always fully unroll the cable.
TECHNICAL DATA
Mains voltage
Mains frequency
Power input
No-load speed
Max. sawing depth (wood)
Max. sawing stroke
Mitre angle
Number of pendulum positions
Weight
NOISE AND VIBRATION
Sound pressure (L )
pa
Acoustic power (L )
wa
Uncertainty (K)
Vibration (wood)
Vibration (metal)
Uncertainty (K)
2
Wear hearing protection.

Vibration level

The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in EN
60745; it may be used to compare one tool with
another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
6
-
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
DESCRIPTION (FIG. A)
Your pendulum action jigsaw has been designed
for sawing wood, metal, plastics, ceramics,
rubber, etc. to any required size and in any
required shape.
1. On/off switch
2. Lock-on button
3. Speed adjustment wheel
4. Pendulum action switch
6. Saw blade holder
7. Saw shoe
V~ 230-240
8. Locking bolt for parallel guide
Hz 50
9. Dust extraction connection
W 750
10. Grip
min 600 - 2,800
-1
11. Allen key
mm 110
mm 20
ASSEMBLY
° +45 - -45
3
3+1
kg 3.25
dB(A) 89
Mounting and removing the saw blade (fig. B)
dB(A) 100
Refer to the table below to select the required
dB(A) 3
saw blade.
m/s 8.87
2
m/s 5.51
2
Saw blade
m/s 1.5
2
Coarse
Medium
Fine
Very fine
2
Fitting a saw blade
Fig. B
The machine is equipped with a quick fit system.
• T urn the clamping ring (13) of the saw blade
may significantly increase the exposure level
the times when the tool is switched off or when
it is running but not actually doing the job, may
signifi cantly reduce the exposure level
5. Guard
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
Material
Wood
Wood
Steel, aluminium, plastic
Wood (curves)
Do not attempt to remove the guard from
the machine.
holder as far to the left as possible and hold it
there.