Mounting The Protective Cover; Removing/Mounting The Protective Cover Extension - Parkside PGKGA 40-Li B2 Traducción Del Manual De Instrucciones Original

GB IE
The saw chain warms up when working
with the saw and thus expands slightly.
These „expansions" can be expected espe-
cially from newer saw chains.
Do not re-tension or change the
saw chain when it is hot because it
shrinks slightly once it has cooled
down. If this is not observed it can
lead to damage on the guide rail or
the motor because the saw chain is
now too taut on the blade bar.
Chain tension and chain lubrication have
a signifi cant impact on the service life of
the saw chain.
The saw chain is properly tensioned when
it does not hang from the underside of the
blade bar and cannot be moved around
by a gloved hand. When pulling on the
saw chain with 9 N (approx. 1 kg) of
force, the saw chain and blade bar should
not be separated by a distance of more
than 2 mm.
10 min
Risk of injury!
Remove the batteries from
the device before working
on the device.
1. Loosen the nut (34) of the sprock-
et cover (33) with the mounting
key (23).
2. Tension the saw chain (1) by
turning the screw (38) in a clock-
wise direction with the mounting
key (23).
Reduce the saw chain tension by
turning the screw anti-clockwise.
58
3. Fix the sprocket cover (33) by
tightening the nut (34) with the
mounting key (23).
The chain tension of a new saw
chain must be readjusted after a
maximum of 5 cuts.
Mounting the protective
cover
The protective cover (14) must be mounted
to the front tubular shaft (2) with the retai-
ner for spool and 3-tooth blade.
1. Screw the protective cover (14) to the
front tubular shaft (2) using the two
small Phillips screws (49). Use the Phil-
lips screwdriver (24) for this.
2. Fasten the cover (50) to the protective
hood (14). Use the hexagon socket
wrench (22) and the three screws (51).
Removing/mounting
the protective cover
extension
If using the 3-tooth blade, the protective
cover extension must be removed.
If using the spool, the extension must be
mounted.
Removing the protective cover
extension:
1. Unlock the lock for the protective cover
extension (16) using a slotted screw-
driver (24) on the side of the line cutter
(15).
2. Remove the protective cover extension
(16).