Working With The Pole-Mounted Pruner; Working Using The Thread Spool; Working With The 3-Tooth Blade - Parkside PGKGA 40-Li B2 Traducción Del Manual De Instrucciones Original

• Always hold the device tightly with
both hands, with one hand on the rear
handle and the other hand on the front
round handle (
Your thumb and fi ngers must tightly
clasp the handles.
• Check the carrying harness (
comfortable positioning which facilita-
tes holding the hedge trimmer.
• If the blades become jammed with
solid objects, switch the device off
immediately, pull the mains plug, and
remove the object.
• Avoid over-stressing the device while
working.
Working with the pole-
mounted pruner
If the saw chain gets stuck,
do not attempt to pull out the
pruner with force. There is a
risk of injury. Turn the motor
off and use a lever arm or
wedge to release the pruner.
• The saw chain should have reached it ma-
ximum speed before you begin sawing.
• You will have better control over the
device if you saw using the lower edge
of the blade bar (saw chain in pulling
direction) and not using the upper edge
of the blade bar (saw chain in pushing
direction).
• The saw chain must not touch the
ground or any object while sawing
through the material or thereafter.
• Ensure that the saw chain does not get
stuck while sawing. The log must not
break or splinter.
• Please also observe the precautionary
measures to protect against kickback
(see the safety information).
5).
A
19) for
A
• Remove branches hanging downwards
by sawing from the top of the branch.
• Twisted branches must be individually
cut down to size.
Working using the thread
spool
• In small grass areas hold the device at
an angle of about 30° and swing the
cutting head evenly to the right and
left with a semi-circular movement.
• The best results are obtained with a
maximum grass length of 15 cm. If the
grass is taller, it is recommended to
mow several times.
• To cut around trees, fence posts or
other obstacles, slowly move the de-
vice around the obstacle and cut with
the thread ends.
• Avoid any contact with fi xed obstacles
(rocks, walls, picket fences, etc.). The
thread would wear out quickly. Use the
edge of the protective cover to keep
the device at the correct distance.
Attention! Do not lay the
cutting head on the ground
during operation!
Working with the 3-tooth
blade
Always wear the harness
and suitable protection clo-
thing when working with the
device. Wear eye, hearing
and head protection.
Ensure that the blade is ins-
talled correctly. Replace da-
maged or blunt tool parts.
There is a risk of injury.
GB IE
63