Russell Hobbs Desire Instrucciones página 66

Read the instructions, keep them safe, pass them on if you pass the appliance on.
Remove all packaging before use.
A IMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
1 This appliance must only be used by or under the supervision of a responsible adult. Use and
store the appliance out of reach of children.
2 Don't put the appliance in liquid, don't use it in a bathroom, near water, or outdoors.
3 Unplug before dismantling or cleaning.
4 Switch off (0) before fitting the jug to the motor unit.
5 Switch off (0), and wait till the blades come to a stop before removing the lid from
the jug, or removing the jug from the motor unit.
6 Don't put your hand into the jug, even after you've removed it from the motor unit
– the blades are sharp.
7 Don't put any other object (spoon, spatula, etc.) into the jug while the blender is plugged in.
8 Don't fill with anything hotter than you can comfortably handle (i.e. liquid temperature
below 40°C).
9 Don't leave the appliance unattended while plugged in.
10 Don't let the jug overflow. If liquid gets under the motor unit, it may be sucked into the motor,
damaging it.
11 Don't use accessories or attachments other than those we supply.
12 Don't use the appliance for any purpose other than those described in these instructions.
13 Don't operate the appliance if it's damaged or malfunctions.
14 If the cable is damaged, it must be replaced by the manufacturer, its service agent, or
someone similarly qualified, in order to avoid hazard.
C PREPARATION
1 Sit the motor unit on a dry, firm, level surface, near a power socket.
2 Route the cable so it doesn't overhang, and can't be tripped over or caught.
3 Align the d on the bottom of the jug with the U on the motor unit.
4 Lower the jug on to the motor unit, then turn the jug to align the d with the L.
5 Remove the lid.
6 Put the ingredients into the jug.
7 Don't fill past the 1.5l mark. If you do, the contents may force the lid off when you start the
motor.
8 Don't fill with anything hotter than you can comfortably handle (i.e. liquid temperature
below 40°C).
9 Replace the lid.
10 Don't run the appliance without fitting the cap.
C SWITCH ON
11 Check that the speed control is set to 0.
12 Put the plug into the power socket.
C SPEED CONTROL
13 Turn the speed control to the speed you want (1 = low, 2 = high).
14 Turn the speed control back to 0 to turn the motor off.
15 Generally, large quantities, thick mixes, and a high ratio of solids to liquids suggest longer
timings and slower speeds.
16 Smaller quantities, thinner mixes, and more liquids than solids suggest shorter timings and
higher speeds.
household use only
66