Carrying Case And; Wrist Strap - Ortovox d3 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

CHANGING BATTERIES
Remove the screw from
the battery compart-
ment (4) and pull the
batteries out of the bat-
tery compartment using
the strap. Insert fresh
AA batteries and pay
attention to the correct
insert position of + pole
and - pole. Only use
brand name batteries.
Cheap batteries can be
slightly thinner and/or
shorter, which means
that correct contact of
the battery poles is not
ensured.
INFORMATION FOR THE USER
Registration Number: FCC ID No. KF5ORTOVOXd3
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) the device may not cause harmful interference and
(2) the device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for an intentional radiator pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonableprotection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio frequency energy and if not
installed and used in accordance with the instructions may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
All manuals and user guides at all-guides.com
REMOVING THE
CARRYING CASE
FROM THE AVALANCHE
TRANSCEIVER
AND MOUNTING
THE WRIST STRAP
The carrying case can
be removed from the
avalanche transceiver
for cleaning purposes.
The wrist strap can be
mounted instead of the
carrying case. Use a
screwdriver to loosen
the small wedge in the
centre of the cord
anchoring. Pull out the
wedge and put it where
it will not get lost.
4
Remove the pear-sha-
ped connecting piece
from the casing with a
strong tug.
Instead of the carrying
case the wrist strap
can be attached. After
attaching the wrist
strap put the connecti-
on back together and
secure with the wedge.
For safety reasons
ORTOVOX recom-
mends that you only
use the supplied and
mounted carrying case.
ENGLISH
39

Publicidad

Tabla de contenido
loading

Productos relacionados para Ortovox d3

Tabla de contenido