Important Safeguards - Kalorik USK DO 3618 Manual De Instrucciones

Fax +32 2 359 95 50

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should
always be followed, including the following:
1. READ ALL INSTRUCTIONS
2. Check that your mains voltage corresponds to that stated on the
rating plate of the appliance before using the appliance.
3. To protect against electrical shock do not immerse cord, plug, or
the motor unit in water or other liquid.
4. Close supervision is necessary when the appliance is used by or
near children.
5. Unplug from outlet when not in use and before putting on or
taking off parts or before cleaning.
6. Do not operate any appliance with a damaged cord or plug or
after the appliance malfunctions or has been damaged in any
manner. Return appliance to the authorized service facility for
examination, repair, or adjustment.
7. The use of accessory attachment not recommended by the
appliance manufacturer may cause fire, electric shock or injuries.
8. Do not use outdoors or for commercial purposes.
9. Do not let cord hang over edge of table or counter or touch hot
surfaces.
10. Do not place on or near a hot gas or electric burner, or in a
heated oven.
11. Always attach plug to appliance first, then plug cord into the wall
outlet. To disconnect remove the plug from the wall outlet.
12. Do not use appliance for other than intended use.
13. Do not open cans under pressure.
14. This kind of appliance cannot function continuously; it is not a
professional type of appliance. It is necessary to make temporary
stops. You should not try to open more than 5 cans in a row,
without letting the motor cool down afterwards for at least 10
minutes.
15. It is absolutely necessary to keep this appliance clean at all times
as it comes into direct contact with food.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
2
Assembly page 2/20
special instruction from Team
Print only
USK DO 36918 - 110808