Berner BHD-2/24 SDS+ Manual Original página 15

Noise and vibrational values (vector sum of three di-
rections) determined according to EN 60745.
The vibration emission level given in this information
sheet has been measured in accordance with a stand-
ardised test given in EN 60745 and may be used to
compare one tool with another. It may be used for a
preliminary assessment of exposure.
The declared vibration emission level represents the
main applications of the tool. However if the tool is
used for different applications, with different accesso-
ries or poorly maintained, the vibration emission may
Mounting and Operation
The following table indicates the action objectives for mounting and operation of the power tool. The instruc-
tions for each action objective are shown aside. Depending on the type of application, various instruction com-
binations are required. Observe the safety instructions.
Action
Selecting a drill chuck
(BHD-2/28 EC SDS+)
Removing the Quick Change
Chuck
(BHD-2/28 EC SDS+)
Inserting the Quick Change
Chuck
(BHD-2/28 EC SDS+)
Inserting SDS-plus Drilling
Tools
Removing SDS-plus Drilling
Tools
Inserting round shank applica-
tions tools
(BHD-2/28 EC SDS+)
Selecting the operating mode
and rotation direction
14 | English
differ. This may significantly increase the exposure lev-
el over the total working period.
An estimation of the level of exposure to vibration
should also take into account the times when the tool
is switched off or when it is running but not actually
doing the job. This may significantly reduce the expo-
sure level over the total working period.
Identify additional safety measures to protect the op-
erator from the effects of vibration such as: maintain
the tool and the accessories, keep hands warm, or-
ganise work patterns.
Figure Please observe
1
2
3
4
5
6
7
Page
155
156
156
157
157
158
158
1 619 929 L30 • 31.7.12