Nozzle Review; Nozzle Connection - A&I Products PW-2300B Manual Del Propietário

INSTALLATION & PREPARATION

NOZZLE REVIEW:

Your pressure washer is equipped with an adjustable nozzle which has two
functions. Review the nozzle assembly instructions listed below. NOTE:
The nozzle assembly should NOT be connected to the gun assembly at this
time.
1. Selections of high and low pressure can be achieved by pulling the
nozzle cover at the end of the wand "TOWARD" yourself for the High
Pressure setting, and pushing the nozzle cover "AWAY" from yourself
for Low Pressure and detergent application.
2. The spray pattern can be adjusted from 0° to 65° by rotating the nozzle
cover at the end of the wand in a clockwise and counterclockwise
direction. Be cautious when using the straight narrow stream. It is not
recommended for use on painted or wood surfaces, or items attached
with adhesive backings.

NOZZLE CONNECTION:

1. Be certain the trigger gun is locked in the "OFF" position. See WARNING,
right.
2. The nozzle assembly should be disconnected from the gun assembly at
this time.
Operator's Manual
DISCONNECT
CONNECT
WARNING
RISK OF INJECTION CAUSING
SEVERE INJURY!
-NEVER LOOK DIRECTLY AT THE
NOZZLE ORIFICE UNLESS IT
IS DISCONNECTED FROM THE
GUN/WAND ASSEMBLY!
-WHEN USING THE ADJUSTABLE
NOZZLE, NEVER ADJUST THE
SPRAY PATTERN WHILE THE
TRIGGER GUN IS OPEN!
ADJUSTABLE NOZZLE
LOW PRESSURE / DETERGENT
NOZZLE COVER
HIGH PRESSURE
NOZZLE COVER
WARNING
RISK OF SEVERE INJURY!
THE TRIGGER GUN SHOULD
ALWAYS BE LOCKED IN THE OFF
POSITION WHEN NOT IN USE!
11